Network Firewall Configuration

From Taridium

(Difference between revisions)
Jump to: navigation, search
(Connecting Multiple Sites)
(Default Ports)
Line 17: Line 17:
This applies particularly to Sonicwall 'SIP Transformations' and Netscreen/Juniper 'SIP ALG' settings.
This applies particularly to Sonicwall 'SIP Transformations' and Netscreen/Juniper 'SIP ALG' settings.
-
It is highly recommended to have a public IP address available for your server if using SIP trunking or if you intend to connect SIP phones over the public internet. If you are using a private IP address or a combination of private IP address and public IP (multi-homed), then make sure the '''externip''' value is set your PUBLIC IP address.
+
It is highly recommended to have a public IP address available for your server if using SIP trunking or if you intend to connect SIP phones over the public internet. If you are using a private IP address or a combination of private IP address and public IP (multi-homed), then make sure the External IP Address '''externip''' value of your SIP General Settings is set your PUBLIC IP address.
=== IAX2 Protocol ===
=== IAX2 Protocol ===

Revision as of 16:28, 18 April 2011

It is always recommended to use a network firewall to protect your PBX from unwanted access. Please consult with your router/firewall vendor for further details.

The ipbx web interface uses standard port TCP 80 or TCP 443 (secure). It is not recommended to expose the web interface to the public internet with standard PIN based user authentication. See End User Panel Login.

Contents

SIP Protocol

If you are planning to use a SIP trunk configure the following ports to be forwarded directly to the server:

Default Ports

 SIP Protocol UDP 5060
 RTP Protocol UDP 18000-20000 (default range as set in RTP configuration)

Warning.gif Do not use SIP transformations or any other NAT traversal solutions on your network firewall unless you completely understand the implications of doing so. Ipbx is capable of handling far-end NAT traversal by setting the peer option to NAT in the channels configuration.

This applies particularly to Sonicwall 'SIP Transformations' and Netscreen/Juniper 'SIP ALG' settings.

It is highly recommended to have a public IP address available for your server if using SIP trunking or if you intend to connect SIP phones over the public internet. If you are using a private IP address or a combination of private IP address and public IP (multi-homed), then make sure the External IP Address externip value of your SIP General Settings is set your PUBLIC IP address.

IAX2 Protocol

IAX2 uses a single UDP data stream to communicate between endpoints, both for signaling and data. The voice traffic is transmitted in-band, making IAX2 easier to firewall and more likely to work behind far-end NAT scenarios.

Default Port

 IAX2 Protocol UDP 4569

Connecting Multiple Sites

Whether you are connecting a couple of phones in a remote office or connecting two ipbx systems, it is always recommended to use a VPN or similar which allows control over bandwidth and use. This can prevent NAT problems and increase your security.

Personal tools
Namespaces
Variants
Actions
Toolbox