Multi Site
From Taridium
| Line 13: | Line 13: | ||
=== Adding Peers === | === Adding Peers === | ||
| - | Click on '''add slave peer''' and enter the remote ip Address as well as descriptive name and extension pattern. In the peer configuration make sure you have your peer set to operate as '''slave''' and configured to use the master's IP address. | + | Click on '''add slave peer''' and enter the remote ip Address as well as descriptive name and extension pattern. Patterns always start with a '_' underscore. In the peer configuration make sure you have your peer set to operate as '''slave''' and configured to use the master's IP address. |
====Special Characters for Pattern Matching==== | ====Special Characters for Pattern Matching==== | ||
| Line 26: | Line 26: | ||
====Examples==== | ====Examples==== | ||
| - | + | _NXXXXXX matches a NANP 7 digit telephone number such as 555-1212 | |
| - | + | _1NXXNXXXXXX matches an area code and phone number preceeded by a one such as 1-860-555-1212 | |
| - | + | _9011. matches any string of at least five characters that starts with 9011, | |
but it does not match the four-character string 9011 itself. | but it does not match the four-character string 9011 itself. | ||
Revision as of 19:24, 9 December 2008
This optional ipbx module is installed under Advanced Setup → Modules. Registered modules are displayed with registered module.
Manage multiple sites from a single master server and simplify communications across all ipbx servers. ipbx's multi site support let's you add cost saving interconnects with very little effort.
Multi Site support allows you to configure a dialplan master server and up to 200 slaves that synchronize dialplan information.
Contents |
Configuring Multi Site
It is recommended to carefully plan your diaplan to avoid overlapping digit patterns across your locations.
To access the multi site configuration click on Advanced Setup → Multi Site. On the master server select Currently operating as Master (default setting). The master IP address is taken from the Advanced Setup → Configuration → ipbx IP Address. This is the IP address used by the slaves to synchronize dialplan information.
Adding Peers
Click on add slave peer and enter the remote ip Address as well as descriptive name and extension pattern. Patterns always start with a '_' underscore. In the peer configuration make sure you have your peer set to operate as slave and configured to use the master's IP address.
Special Characters for Pattern Matching
X matches any digit from 0-9
Z matches any digit from 1-9
N matches any digit from 2-9
[1237-9] matches any digit or letter in the brackets
(in this example, 1,2,3,7,8,9)
. wildcard, matches one or more characters
Examples
_NXXXXXX matches a NANP 7 digit telephone number such as 555-1212
_1NXXNXXXXXX matches an area code and phone number preceeded by a one such as 1-860-555-1212
_9011. matches any string of at least five characters that starts with 9011,
but it does not match the four-character string 9011 itself.
Master Failure
If for some reason the master becomes unreachable, slaves default to cached information and revert back to live information as soon as it becomes available again.
